EIGRP

Network statement does not control what networks are being advertised but instead what interfaces are running EIGRP process Uses protocol number 88 Multicast to 224.0.0.10 (TTL=0) Receiving neighbour unicasts are acknowledged Unequal cost load sharing of up to 16 links EIGRP does not form neighbours over…

RIP Configuration

The following are the various RIP configuration commands on Cisco routers. Notes on RIP can be found here. RIP router rip network #subnet to advertise/enable RIP on passive-interface #dont send/process updates neighbour #unicast message to destination IP offset-list (in|out) #manipulate route metric version (2|1) #RIP version…

RIP

General RIP UDP-520 2 message types; - Request Message (used to ask neighbours to send updates) Response Message (Carries an update) Metric is hop-count On startup RIP broadcasts a request message packet out each RIP enabled interface - The RIP process then enters a loop - Listening for RIP requests…